Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
85669
1.INSTALL HEADLIGHT LEVELING MOTOR BASE PACKING
Install the headlight leveling motor base packing to the headlight levering motor.
85662
2.INSTALL HEADLIGHT LEVELING MOTOR (for LED Headlight)
Insert the headlight leveling motor.
| *a | Aiming Screw |
Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (1) shown in the illustration to engage the shaft.
Turn the headlight leveling motor in the direction indicated by the arrow (2) shown in the illustration to install it.
When installing the headlight leveling motor of the headlight assembly RH, turn the headlight leveling motor in the opposite direction indicated by the arrow (2) shown in the illustration.
Install the stopper with the screw.
81510C
3.INSTALL FRONT TURN SIGNAL LIGHT BULB (for Halogen Headlight)
Install the front turn signal light bulb into the front turn signal light socket.
Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration to install them as a unit.
81510C
4.INSTALL FRONT TURN SIGNAL LIGHT BULB (for LED Headlight)
Install the front turn signal light bulb into the front turn signal light socket.
Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration to install them as a unit.
Engage the claw and clamp to connect the connector.
81610F
5.INSTALL CLEARANCE LIGHT BULB (for Halogen Headlight)
Install the clearance light bulb into the clearance light socket.
Turn the clearance light socket with the clearance light bulb in the direction indicated by the arrow in the illustration to install them.
81610F
6.INSTALL CLEARANCE LIGHT BULB (for LED Headlight)
Install the clearance light bulb into the clearance light socket.
Turn the clearance light socket with the clearance light bulb in the direction indicated by the arrow in the illustration to install them.
81110B
7.INSTALL NO. 1 HEADLIGHT BULB (for Halogen Headlight)
Install the No. 1 headlight bulb.
Do not touch the No. 1 headlight bulb glass.
Lock the set spring in the direction indicated by the arrow in the order shown in the illustration.
Install the socket cover.
81110B
8.INSTALL NO. 1 HEADLIGHT BULB (for LED Headlight)
Install a new headlight gasket to the socket cover.
Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.
Do not touch the No. 1 headlight bulb glass.
Connect the connector.
Turn the socket cover in the direction indicated by the arrow show in the illustration to install it.
81108
9.INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY (for LED Headlight)
Install a new headlight gasket to the back cover.
Install the headlight light control ECU sub-assembly with the 2 screws.
Connect the connector.
Turn the back cover in the direction indicated by the arrow show in the illustration to install it.