Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
81564C
1.REMOVE REAR COMBINATION LIGHT BODY PACKING
Remove the rear combination light body packing.
Be sure to remove all the traces of the old rear combination light body packing from the body.
Do not reuse the removed packing. Be sure to install a new rear combination light body packing to prevent water ingress.
81550F
2.REMOVE TAIL LIGHT BULB (except Sport Package)
Turn the rear combination light socket and wire sub-assembly with the tail light bulb in the direction indicated by the arrow shown in the illustration to separate them from the rear combination light lens and body as a unit.
Remove the tail light bulb from the rear combination light socket and wire sub-assembly.
81550L
3.REMOVE REAR TURN SIGNAL LIGHT BULB (except Sport Package)
Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration to separate them from the rear combination light lens and body as a unit.
Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.
81550L
4.REMOVE REAR TURN SIGNAL LIGHT BULB (for Sport Package)
Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration to separate them from the rear combination light lens and body as a unit.
Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.
81550N
5.REMOVE BACK UP LIGHT BULB (except Sport Package)
Turn the rear combination light socket and wire sub-assembly with the back up light bulb in the direction indicated by the arrow shown in the illustration to separate them from the rear combination light lens and body as a unit.
Remove the back up light bulb from the rear combination light socket and wire sub-assembly.
81550N
6.REMOVE BACK UP LIGHT BULB (for Sport Package)
Turn the rear combination light socket and wire sub-assembly with the back up light bulb in the direction indicated by the arrow shown in the illustration to separate them from the rear combination light lens and body as a unit.
Remove the back up light bulb from the rear combination light socket and wire sub-assembly.
81565
7.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (except Sport Package)
Disconnect the connector.
Disengage the clamp and guide to remove the rear combination light socket and wire sub-assembly.
| *a | Clamp |
| *b | Guide |
81565
8.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (for Sport Package)
Disconnect the connector.
Disengage the clamp and guide to remove the rear combination light socket and wire sub-assembly.
| *a | Clamp |
| *b | Guide |
81568E
9.REMOVE REAR COMBINATION LIGHT COVER (for Sport Package)
Remove the 2 screws and rear combination light cover.
81568J
10.REMOVE REAR COMBINATION LIGHT PROTECTOR
Remove the 2 screws and rear combination light protector.