Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY › 2011.08–2017.01
RM19S0E _59 Vehicle Exterior _051505 LIGHTING (EXT) _0248419 REAR COMBINATION LIGHT ASSEMBLY G

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 81560 1.INSPECT REAR COMBINATION LIGHT ASSEMBLY LH

a.
U158528E02
0.281,0.177 0.479,0.344 0.198,0.167 10 false *a 2.708,1.927 2.99,2.073 0.281,0.146 10 false K37

Disconnect the connector from the rear combination light assembly LH.

Text in Illustration
*a Front view of wire harness connector
(to Rear Combination Light Assembly LH)


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
K37-4 - K37-6 Light control switch OFF Below 1 V
Light control switch in TAIL 11 to 14 V
K37-1 - K37-6 Brake pedal released Below 1 V
Brake pedal depressed 11 to 14 V
K37-2 - K37-6 Turn signal switch OFF Below 1 V
Ignition switch ON and Turn signal switch in LH 11 to 14 V (60 to 120 times per minute)
K37-5 - K37-6 Shift lever not in R Below 1 V
Shift lever in R 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.


Hide 81550 2.INSPECT REAR COMBINATION LIGHT ASSEMBLY RH

a.
U158529E01
0.329,0.267 0.534,0.428 0.205,0.161 10 *a 2.695,1.88 2.964,2.025 0.269,0.145 10 K38

Disconnect the connector from the rear combination light assembly RH.

Text in Illustration
*a Front view of wire harness connector
(to Rear Combination Light Assembly RH)


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
K38-4 - K38-6 Light control switch OFF Below 1 V
Light control switch in TAIL 11 to 14 V
K38-1 - K38-6 Brake pedal released Below 1 V
Brake pedal depressed 11 to 14 V
K38-2 - K38-6 Turn signal switch OFF Below 1 V
Ignition switch ON and Turn signal switch in RH 11 to 14 V (60 to 120 times per minute)
K38-5 - K38-6 Shift lever not in R Below 1 V
Shift lever in R 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.