81570
1.INSTALL CENTER STOP LIGHT ASSEMBLY
Install a new packing.
Engage the 4 claws to install a new clip.
| *a | Upper Side (side with short claws) |
| *b | Lower Side (side with long claws) |
Make sure not to install the metal clip upside-down.
Use the same procedure as for the opposite side.
Connect the connector.
Engage the 4 claws of the metal clips and install the center stop light assembly.
Make sure not to deform the packing at this point.
81952D
2.INSTALL REAR LIGHT COVER
Engage the 6 claws to install the rear light cover.