Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › 2011.08–2017.10
RM19S0E _59 Vehicle Exterior _051505 LIGHTING (EXT) _0248423 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84330 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.
E136319E27
0.123,0.043 0.387,0.245 0.263,0.202 10 *a

Check the hazard warning signal light switch function.

Text in Illustration
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance::
Tester Connection Switch Condition Specified Condition
1(E) - 4(TB) Pushed Below 1 Ω
Not pushed 10 kΩ or higher


If the result is not as specified, replace the hazard warning signal light switch assembly.



b.
E136319E27
0.123,0.043 0.387,0.245 0.263,0.202 10 *a

Check the illumination operation.

Text in Illustration
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)

i.

Apply battery voltage to the hazard warning signal light switch assembly connector.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 3(ILL+)
Battery positive (-) → 2(ILL-)
The illumination comes on


If the result is not as specified, replace the hazard warning signal light switch assembly.