Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR
RM19S0E _59 Vehicle Exterior _051505 LIGHTING (EXT) _0248425 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89120A 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

a.

Disconnect the automatic light control sensor connector.


b.
E222418E02
0.514,1.138 0.887,1.289 0.373,0.151 10 CLTB 2.505,1.592 2.930,1.743 0.426,0.151 10 CLTE 1.522,1.211 1.003,1.211 false 2.463,1.666 1.944,1.449 false 0.133,0.084 0.316,0.327 0.184,0.244 10 *a

Measure the voltage according to the value(s) in the table below.

Text in Illustration
*a Front view of wire harness connected
(to Automatic Light Control Sensor)

Standard Voltage:
Tester Connection Switch Condition Specified Condition
3 (CLTB) - 5 (CLTE) Ignition switch off Below 1 V
Ignition switch on 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (CLTE) -Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the wire harness or connector.


d.

Reconnect the automatic light control sensor connector.


e.
E222419E02
0.774,1.606 1.157,1.766 0.383,0.161 10 CLTE 0.705,0.942 1.087,1.102 0.383,0.161 10 CLTS 1.166,1.037 1.567,1.037 false 0.12,0.082 0.389,0.309 0.269,0.228 10 *a 1.581,1.232 1.236,1.577 false

Connect an oscilloscope to the automatic light control sensor connector.

Text in Illustration
*a Rear view of wire harness connector
(to Automatic Light Control Sensor)


f.
B113714E01
2.948,1.063 3.292,1.219 0.344,0.156 10 GND 1.844,1.177 1.969,1.333 0.125,0.156 10 A

Check the waveform.

OK:
Tester Connection Tool Setting Condition Specified Condition
4 (CLTS) - 5 (CLTE) 5 V/DIV., 5 ms./DIV Ignition switch ON, light control switch in AUTO Correct waveform is as shown


HINT:

If the ambient light becomes brighter, width A becomes narrower.


If the result is not as specified, replace the automatic light control sensor.