Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2014.07
RM19S0E _59 Vehicle Exterior _051505 LIGHTING (EXT) _0248427 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM U

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  FAIL-SAFE CHART  


AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM


a.

The headlight leveling ECU assembly operates in fail-safe mode if an abnormal condition such as those listed below has been detected, and keep the last low beam status.

Item Abnormality Detection Condition Return Condition Warning Indicator
Height control sensor power source voltage Abnormal height control sensor power source voltage (4.6 V or less, or 6.25 V or more) is detected. Abnormal voltage is not detected for 5 seconds consecutively Illuminated
Height control sensor signal voltage Abnormal height control sensor signal voltage (0.25 V or less, or 4.75 V or more) is detected.
High power source voltage Abnormal high IG supply voltage (18.5 V or more) is detected. Voltage of 17.5 V or less is detected Not illuminated
Low power source voltage Abnormal low IG supply voltage (9.0 V or less) is detected. Voltage of 9.3 V or more is detected for 0.1 seconds consecutively Not illuminated
Reset while running Reset by a temporary loss of power etc. while driving. Vehicle is stopped Not illuminated