Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR › from 2014.07
RM19S0E _59 Vehicle Exterior _051505 LIGHTING (EXT) _0248428 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89407A 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

a.

Connect 3 dry cell batteries (1.5 V) in series.

NOTICE:

Do not use rechargeable batteries as they may not output a voltage of 1.5 V.



b.

Connect a positive (+) lead from the batteries to terminal 3 (SHB) and a negative (-) lead to terminal 1 (SHG).

E151424E04
5.193,1.216 5.460,1.474 0.267,0.258 10 *d 3.292,0.272 3.559,0.530 0.267,0.258 10 *a 4.292,1.281 4.559,1.539 0.267,0.258 10 *b 4.067,2.766 4.334,3.024 0.267,0.258 10 *c 5.24,2.393 5.738,2.586 0.498,0.193 10 SHB 6.314,2.393 6.812,2.586 0.498,0.193 10 SHG 5.707,2.393 6.205,2.586 0.498,0.193 10 SHRR 5.909,1.887 5.909,2.372 false 5.734,1.889 5.415,2.367 false 6.073,1.889 6.452,2.364 false 3.913,0.683 4.204,0.889 0.290,0.205 10 -45° 4.209,2.342 4.527,2.548 0.318,0.205 10 +45° 4.305,1.632 4.697,1.798 0.392,0.165 10 -17.6°

Text in Illustration
*a Low *b Standard position
*c High *d Component without harness connected
(Rear Height Control Sensor Sub-assembly RH)


c.

Check the voltage.

i.

Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (SHRR) - 1 (SHG) +45° (High) 3.8475 to 4.2525 V
0°(Standard position) 2.1735 to 2.3265 V
-45°(Low) 0.2475 to 0.6525 V


If the result is not as specified, replace the rear height control sensor sub-assembly RH.