52164A
1.INSTALL REAR BUMPER PLATE LH (for Type A)
Install the rear bumper plate with the 3 bolts.
52163A
2.INSTALL REAR BUMPER PLATE RH (for Type A)
Use the same procedure as for the LH side.
52172B
3.INSTALL REAR NO. 2 BUMPER REINFORCEMENT (for Type B)
Engage the 2 guides and install the rear bumper reinforcement.
52164A
4.INSTALL REAR BUMPER PLATE LH (for Type B)
Use the same procedure as for the Type A side.
52163A
5.INSTALL REAR BUMPER PLATE RH (for Type B)
Use the same procedure as for the LH side.
52172B
6.INSTALL REAR NO. 2 BUMPER REINFORCEMENT (for Type C)
Use the same procedure as for the Type B side.
52182
7.INSTALL REAR BUMPER ARM LH (for Type C)
Install the rear bumper arm with the 3 bolts.
52181
8.INSTALL REAR BUMPER ARM RH (for Type C)
Use the same procedure as for the LH side.
9.INSTALL REAR BUMPER REINFORCEMENT (for Type C)
Install the rear bumper reinforcement with the 4 nuts.
52156A
10.INSTALL REAR BUMPER SIDE SUPPORT LH
Engage the 2 claws and install the rear bumper side support.
Tighten the screw.
52155A
11.INSTALL REAR BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
52576
12.INSTALL REAR BUMPER SIDE RETAINER LH
Engage the guide and 2 claws and install the rear bumper side retainer.
Tighten the screw.
52575
13.INSTALL REAR BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.
52592
14.INSTALL REAR BUMPER SIDE SEAL LH
Install the rear bumper side seal with the 2 clips.
52591
15.INSTALL REAR BUMPER SIDE SEAL RH
Use the same procedure as for the LH side.
52164A
16.INSTALL REAR BUMPER PLATE LH (w/ Reflex Reflector Assembly)
Engage the 2 claws and install the rear bumper plate.
Tighten the screw.
52163A
17.INSTALL REAR BUMPER PLATE RH (w/ Reflex Reflector Assembly)
Use the same procedure as for the LH side.