Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR SPOILER
RM19S0E _59 Vehicle Exterior _051507 EXTERIOR PANELS / TRIM _0248435 REAR SPOILER A

EXTERIOR PANELS / TRIM  REAR SPOILER  INSTALLATION  


PROCEDURE

Hide 76085 1.INSTALL REAR SPOILER SUB-ASSEMBLY

a.

Clean the attachment surface.

i.

Using an infrared light, heat the double-sided adhesive tape remaining on the back door panel.

Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)

CAUTION:

Do not burn yourself on the hot back door panel or with the infrared light.


NOTICE:

Do not heat the back door panel excessively.



ii.

Using a piece of cloth, rub the remaining double-sided tape off the back door panel while it is hot from the infrared light.

NOTICE:

Installing the rear spoiler while any double-sided tape remains on the back door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.



iii.

Using a non-residue solvent, clean the attachment surface.



b.

Engage the 4 clips and install a new rear spoiler.


c.

Tighten the 2 screws.


Hide 76894 2.INSTALL REAR SPOILER COVER LH

a.
B273186

Engage the 2 claws and install the rear spoiler cover.


Hide 76893A 3.INSTALL REAR SPOILER COVER RH

HINT:

Use the same procedure as for the LH side.