Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › SIDE MUDGUARD
RM19S0E _59 Vehicle Exterior _051507 EXTERIOR PANELS / TRIM _0248439 SIDE MUDGUARD A

EXTERIOR PANELS / TRIM  SIDE MUDGUARD  INSTALLATION  


PROCEDURE

Hide 76926D 1.INSTALL SIDE MUDGUARD PROTECTOR

a.

Using a piece of cloth, rub the remaining double-sided adhesive tape off the side mudguard protector.

NOTICE:

Installing the side mudguard protector with any double-sided tape remaining on the side mudguard may cause adhesion failure. Therefore, completely remove the double-sided tape.



b.

Using a non-residue solvent, clean the attachment surface.


c.

Apply Primer M to the installation part of the side mudguard.

HINT:

If primer is applied to an area that is not specified, wipe off the primer with a non-residue solvent before it dries.



d.

Install a new side mudguard protector onto the side mudguard.

NOTICE:
·

Allow the primer to dry for 3 minutes or more.

·

Throw away any leftover primer.

·

Do not apply too much primer.




Hide 76928A 2.INSTALL SIDE MUDGUARD REAR PROTECTOR

a.

Using a piece of cloth, rub the remaining double-sided adhesive tape off the side mudguard rear protector.

NOTICE:

Installing the side mudguard rear protector with any double-sided tape remaining on the side mudguard may cause adhesion failure. Therefore, completely remove the double-sided tape.



b.

Using a non-residue solvent, clean the attachment surface.


c.

Apply Primer M to the installation part of the side mudguard.

HINT:

If primer is applied to an area that is not specified, wipe off the primer with a non-residue solvent before it dries.



d.

Install a new side mudguard rear protector onto the side mudguard.

NOTICE:
·

Allow the primer to dry for 3 minutes or more.

·

Throw away any leftover primer.

·

Do not apply too much primer.




Hide 76902 3.INSTALL SIDE MUDGUARD SUB-ASSEMBLY

a.

Engage the 7 clips and install the side mudguard.


b.

Install the 8 retainers.


c.

Tighten the screw.


Hide 75858 4.INSTALL ROCKER PANEL MOULDING COVER

a.

Engage the 2 claws and install the rocker panel moulding cover.