Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
75858
1.REMOVE ROCKER PANEL MOULDING COVER
Using a moulding remover, disengage the 2 claws and remove the rocker panel moulding cover.
| *1 | Moulding Remover |
76902
2.REMOVE SIDE MUDGUARD SUB-ASSEMBLY
Remove the screw.
Remove the 8 retainers.
Disengage the 7 clips and remove the side mudguard.
76928A
3.REMOVE SIDE MUDGUARD REAR PROTECTOR
While peeling off the double-sided adhesive tape, remove the side mudguard rear protector.
76926D
4.REMOVE SIDE MUDGUARD PROTECTOR
While peeling off the double-sided adhesive tape, remove the side mudguard protector.