Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
75752C
1.REMOVE FRONT DOOR WINDOW FRAME FRONT MOULDING
Using an infrared light, heat the rear door window frame rear moulding.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
Do not burn yourself on the hot body panel or with the infrared light.
Do not heat the vehicle body excessively.
Remove any tape remaining on the rear door panel.
Disengage the clip while peeling off the double-sided adhesive tape.
| *1 | Double-sided Tape |
Disengage the 2 guides and front door window frame front moulding.