1.REMOVE FRONT BUMPER ASSEMBLY
Apply protective tape, as shown in the illustration.
| *a | Protective Tape |
Use the same procedure as for the opposite side.
Remove the 4 clips.
Remove the 5 screws and 3 bolts.
w/ Fog Light:
Disengage the 7 claws to separate the front bumper assembly.
Use the same procedure as for the opposite side.
Disconnect the 2 connectors to remove the front bumper assembly.
w/o Fog Light:
Disengage the 7 claws to remove the front bumper assembly.
Use the same procedure as for the opposite side.
Remove the 3 grommets.
Remove the 2 nuts.