53395E
1.REMOVE HOOD TO FRONT END PANEL SEAL
Remove the 4 clips.
While peeling off the double-sided tape, remove the hood to front end panel seal.
52129B
2.REMOVE FRONT BUMPER LOWER COVER
Turn the front bumper hole cover and disengage the 3 claws.
Disengage the hook to remove the front bumper lower cover.
53112E
3.INSTALL LOWER NO. 1 RADIATOR GRILLE
Remove the 2 clips.
Remove the 4 screws.
Disengage the 20 claws and 2 guides to remove the lower No. 1 radiator grille.
53124D
4.REMOVE RADIATOR GRILLE LOWER MOULDING LH
Remove the 3 screws.
Disengage the 4 claws and guide to remove the radiator grille lower moulding LH.
53123C
5.REMOVE RADIATOR GRILLE LOWER MOULDING RH
Use the same procedure as for the LH side.
53111
6.REMOVE RADIATOR GRILLE
Remove the 3 clips.
Disengage the 11 claws to remove the radiator grille.
75311
7.REMOVE RADIATOR GRILLE (OR FRONT PANEL) EMBLEM
Disengage the 4 claws and 2 guides to remove the radiator grill (or front panel) emblem.
53121B
8.REMOVE RADIATOR GRILLE UPPER MOULDING
Disengage the 9 claws to remove the radiator grille upper moulding.
53122A
9.REMOVE RADIATOR GRILLE LOWER MOULDING
Remove the 4 screws.
Disengage the 5 claws and 6 guides to remove the radiator grille lower moulding.
81220
10.REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)
81210A
11.REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)
Use the same procedure as for the LH side.
81482C
12.REMOVE FOG LIGHT COVER LH (w/ Fog Light)
Disengage the 5 claws to remove the fog light cover.
81481E
13.REMOVE FOG LIGHT COVER RH (w/ Fog Light)
Use the same procedure as for the LH side.
81482C
14.REMOVE FOG LIGHT COVER LH (w/o Fog Light)
Disengage the 5 claws to remove the fog light cover.
81481E
15.REMOVE FOG LIGHT COVER RH (w/o Fog Light)
Use the same procedure as for the LH side.
52722
16.REMOVE FRONT BUMPER EXTENSION MOULDING LH (w/ Fog Light)
Disengage the 4 claws and 3 guides to remove the front bumper extension moulding LH.
52721
17.REMOVE FRONT BUMPER EXTENSION MOULDING RH (w/ Fog Light)
Use the same procedure as for the LH side.
81150
18.REMOVE HEADLIGHT ASSEMBLY LH
81110
19.REMOVE HEADLIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
52536
20.REMOVE FRONT BUMPER SIDE RETAINER LH
Disengage the 2 claws to remove the front bumper side retainer LH.
52535
21.REMOVE FRONT BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.
88790B
22.REMOVE THERMISTOR ASSEMBLY
Disengage the clamp to separate the wire harness.
Disconnect the connector.
Disengage the clamp to remove the thermistor assembly.
53288B
23.REMOVE RADIATOR SUPPORT EXTENSION LH
Disengage the 2 claws to remove the radiator support extension LH.
53287B
24.REMOVE RADIATOR SUPPORT EXTENSION RH
Use the same procedure as for the LH side.
53292A
25.REMOVE UPPER RADIATOR SUPPORT SEAL
Remove the 4 clips and upper radiator support seal.
53286B
26.REMOVE NO. 2 RADIATOR SIDE AIR SEAL
Disengage the 2 claws to remove the No. 2 radiator side air seal.
53285B
27.REMOVE NO. 1 RADIATOR SIDE AIR SEAL
Use the same procedure as for the No. 2 radiator side air seal side.
52611
28.REMOVE FRONT BUMPER ENERGY ABSORBER
Disengage the 2 guides to remove the front bumper energy absorber.
52131A
29.REMOVE FRONT BUMPER REINFORCEMENT
Disengage the 2 clamps to disconnect the wire harness.
Remove the 6 bolts.
Remove the 4 nuts and front bumper reinforcement.
53165A
30.REMOVE FRONT NO. 1 BUMPER STONE DEFLECTOR BRACKET
Remove the 2 nuts and front No. 1 bumper stone deflector bracket.
Use the same procedure as for the opposite side.
85330
31.SEPARATE WINDSHIELD WASHER JAR ASSEMBLY
Remove the bolt and separate the windshield washer jar assembly.
57014A
32.REMOVE FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY LH
Remove the 4 bolts.
Disengage the 2 guides to remove the front side member bracket sub-assembly LH.
57013C
33.REMOVE FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
51442C
34.REMOVE ENGINE UNDER COVER LH
51441C
35.REMOVE ENGINE UNDER COVER RH
52601
36.REMOVE FRONT BUMPER ENERGY ABSORBER SUB-ASSEMBLY
Remove the 6 screws, 6 clips and grommet.
Disengage the 3 hooks to remove the front bumper energy absorber sub-assembly.