Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2016.09
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0248153 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0500  Vehicle Speed Sensor Malfunction  


DESCRIPTION

The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. The skid control ECU converts these wheel speed signals into a pulse signal and outputs it to the ECM via the combination meter. The ECM determines the vehicle speed based on the frequency of this pulse signal.

DTC Code DTC Detection Condition Trouble Area
P0500 The vehicle speed signal from the skid control ECU is cut for 0.14 seconds or more while cruise control is in operation.
·

Vehicle speed sensor signal circuit

·

Vehicle speed sensor

·

Combination meter assembly

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

This DTC may be stored under the SFI system at the same time. In that case, perform troubleshooting for the SFI system first.


PROCEDURE

1.CHECK FOR DTC

b.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).



c.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

DTC P0500 is not output.


Result
Result Proceed to
DTC is not output A
DTC P0500 is output (for 2NZ-FE) B
DTC P0500 is output (for 1NZ-FE) C



A

B

C