Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR › from 2016.09
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0292836 HEATED OXYGEN SENSOR A

2NZ-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


PROCEDURE

Hide 58910C 1.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 89465A 2.REMOVE HEATED OXYGEN SENSOR

a.
A250513

Disconnect the heated oxygen sensor connector.


b.

Remove the heated oxygen sensor wire grommet and pass the connector through the hole to the outside of the vehicle.


c.
A247793E01
1.994,0.273 2.102,0.273 false 1.876,0.623 1.994,0.273 1.994,0.273 2.102,0.273 false 2.108,0.185 2.645,0.398 0.537,0.213 10 SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

SST
09224-00012  

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.