89465A
1.INSTALL HEATED OXYGEN SENSOR
| *a | Torque Wrench Fulcrum Length |
| *b | SST Fulcrum Length |
Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.
If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):
39 N*m (398 kgf*cm, 29 ft.*lbf)
Perform "Inspection After Repairs" after replacing the heated oxygen sensor.
Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
Pass the connector through the hole into the inside of the vehicle and install the heated oxygen sensor wire grommet.
Connect the heated oxygen sensor connector.
2.INSPECT FOR EXHAUST GAS LEAK
58910C
3.INSTALL REAR CONSOLE BOX ASSEMBLY
4.PERFORM INITIALIZATION
Perform "Inspection After Repairs" after replacing the heated oxygen sensor.
Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION