Home › General › SPECIFICATIONS › 2NZ-FE ENGINE CONTROL › from 2016.09
RM19S0E _V1 General _051446 SPECIFICATIONS _0247979 2NZ-FE ENGINE CONTROL F

SPECIFICATIONS  2NZ-FE ENGINE CONTROL  TORQUE SPECIFICATIONS  


Part tightened N*m kgf*cm ft.*lbf
Camshaft timing oil control valve assembly x Cylinder head assembly 7.5 76 66 in.*lbf
Mass air flow meter x Air cleaner cap 1.0 10 9 in.*lbf
Battery clamp x Battery carrier 3.5 36 31 in.*lbf
Throttle body assembly x Intake manifold 9.0 92 80 in.*lbf
Water filler sub-assembly x Throttle with motor body assembly 7.5 76 66 in.*lbf
Throttle body assembly x Wire harness bracket 9.0 92 80 in.*lbf
Air cleaner cap sub-assembly x No. 1 air cleaner hose 3.0 31 27 in.*lbf
ECM x body 8.0 82 71 in.*lbf
Accelerator pedal assembly x body 5.4 55 48 in.*lbf
Camshaft position sensor x Cylinder head assembly 8.0 82 71in.*lbf
Crankshaft position sensor x Oil pump assembly 7.5 76 66 in.*lbf
Spark plug x Cylinder head assembly 18 184 13
No. 1 ignition coil x Cylinder head assembly 9.0 92 80 in.*lbf
No. 2 cylinder head cover x Cylinder head assembly 7.0 71 62 in.*lbf
Engine coolant temperature sensor x Cylinder head assembly 20 204 15
Knock sensor x Cylinder block assembly 20 204 15
Air fuel ratio sensor x Exhaust manifold
without SST
44 449 32
Air fuel ratio sensor x Exhaust manifold
with SST
39 398 29
Heated oxygen sensor x front exhaust pipe assembly
without SST
44 449 32
Heated oxygen sensor x front exhaust pipe assembly
with SST
39 398 29