Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Driver Side) › from 2016.09
RM19S0E _58 Vehicle Interior _051496 SEAT _0248331 FRONT SEAT ASSEMBLY(for Driver Side) A

SEAT  FRONT SEAT ASSEMBLY(for Driver Side)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).(w/ Front Seat Side Airbag)

·

If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one. (w/ Front Seat Side Airbag)



NOTICE:

Always use "TORX" socket wrench E10 when removing the front seat.


HINT:

The procedure described below is for the LHD side. Use the same procedure for both the LHD and RHD side, unless otherwise specified.


PROCEDURE

Hide 1. PRECAUTION (w/ Front Seat Side Airbag)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 72138 3.REMOVE SEAT TRACK OUTER COVER

a.

Move the seat to the foremost position.


b.
B272740

Disengage the 2 claws to remove the seat track outer cover.


Hide 4.REMOVE FRONT SEAT ASSEMBLY

a.

Disconnect the buckle switch connector. (w/ Wire Harness)


b.

Disconnect the front seat side airbag connector. (w/ Front Seat Side Airbag)

C190412E06
1.869,2.092 2.037,2.245 0.169,0.154 10 *1 1.945,0.885 1.945,2.066 false 3.631,0.871 3.631,2.08 false 3.555,2.099 3.723,2.252 0.169,0.154 10 *1

Text in Illustration
*1 Slider - -

i.

Place a finger on the slider, slide the slider to release the lock, and then disconnect the front seat side airbag connector.



c.
B283297

Using an E10 "TORX" socket wrench, remove the 2 bolts on the rear side of the seat.


d.

Move the seat to the rearmost position.


e.

Using an E10 "TORX" socket wrench, remove the 2 bolts on the front side of the seat.


f.

Lift up the seat track adjusting handle. (w/ Vertical Adjuster)


g.

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.