Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Driver Side) › from 2016.09
RM19S0E _58 Vehicle Interior _051496 SEAT _0248331 FRONT SEAT ASSEMBLY(for Driver Side) A

SEAT  FRONT SEAT ASSEMBLY(for Driver Side)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).(w/ Front Seat Side Airbag)

·

If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one. (w/ Front Seat Side Airbag)



NOTICE:

Always use E10 "TORX" socket wrench when removing the front seat.


HINT:

The procedure described below is for the LHD side. Use the same procedure for both the LHD and RHD side, unless otherwise specified.


PROCEDURE

Hide 1.INSTALL FRONT SEAT ASSEMBLY

B287403E04
2.99,2.333 3.115,2.49 0.125,0.156 10 false 1 1.99,1.896 2.115,2.052 0.125,0.156 10 true 2 2.302,3.167 2.427,3.323 0.125,0.156 10 false 3 0.292,2.469 0.417,2.625 0.125,0.156 10 false 4

NOTICE:
·

Follow the procedure described below in order to prevent the seat tracks from locking separately.

·

Be careful not to damage the vehicle body.



a.

Insert the 2 location pins through the 2 body holes to temporarily install the front seat assembly, place the front seat in the foremost position and make sure that the inner and outer seat tracks are locked securely.


b.

Using an E10 "TORX" socket wrench, install bolt 1 and then bolt 2 onto the rear side.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


c.

Move the front seat to the rearmost position, and then make sure that the inner and outer seat tracks are securely locked.


d.

Using an E10 "TORX" socket wrench, install bolt 3 and then bolt 4 onto the front side.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


e.

Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.

HINT:

If the inner and outer seat tracks do not lock simultaneously, loosen the bolts and adjust the seat tracks.



f.

Connect the buckle switch connector. (w/ Wire Harness)


g.

Connect the front seat side airbag connector. (w/ Front Seat Side Airbag)


Hide 72138 2.INSTALL SEAT TRACK OUTER COVER

a.

Move the seat to the foremost position.


b.

Engage the 2 claws to install the seat track outer cover.


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION