Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › from 2016.09
RM19S0E _58 Vehicle Interior _051495 SUPPLEMENTAL RESTRAINT SYSTEMS _0248316 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45186 3.REMOVE LOWER NO. 2 STEERING WHEEL COVER

B282589E02
1.615,0.708 1.281,0.958 true 1.625,0.625 1.833,0.823 0.208,0.198 10 true *1

a.

Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the lower No. 2 steering wheel cover.

Text in Illustration
*1 Protective Tape


Hide 45130 4.REMOVE STEERING PAD

B282590

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Using a "TORX" driver, push in the 3 snap rings to disengage it from the 3 pins.

NOTICE:

Lightly hold the steering pad to prevent it from falling.



d.

Pull the steering pad toward rear.

NOTICE:

When removing the steering pad, do not pull the airbag wire harness.



e.

Using a screwdriver with its tip wrapped with protective tape, release the locking button.


f.
B282591E01
0.769,2.582 1.219,2.775 false 1.25,2.729 1.419,2.911 0.169,0.181 10 *1 2.075,2.322 2.525,2.326 false 1.856,2.236 2.025,2.417 0.169,0.181 10 *2

Disconnect the airbag connector.

NOTICE:

When disconnecting the airbag connector, take care not to damage the airbag wire harness.


Text in Illustration
*1 Protective Tape
*2 Locking button


g.

Disconnect the horn terminal.