Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › from 2016.09
RM19S0E _58 Vehicle Interior _051495 SUPPLEMENTAL RESTRAINT SYSTEMS _0248316 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


PROCEDURE

Hide 45130 1.INSTALL STEERING PAD

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B282592E01
2.117,2.653 1.66,2.266 false 1.512,2.184 1.668,2.333 0.155,0.149 10 *1

Connect the airbag connector.

Text in Illustration
*1 Locking Button


d.

Push in the locking button.

NOTICE:
·

Do not damage the airbag wire harness when connecting the airbag connector.

·

Securely lock the locking button.




e.

Connect the horn terminal.


f.
B293017

Engage the 3 pins with the 3 snap rings to install the steering pad.

NOTICE:

Pull the steering pad to ensure that it is securely engaged.



Hide 45186 2.INSTALL LOWER NO. 2 STEERING WHEEL COVER

a.

Engage the 2 claws to install the lower No. 2 steering wheel cover.


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION