Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY(for Driver Side) › from 2016.09
RM19S0E _58 Vehicle Interior _051495 SUPPLEMENTAL RESTRAINT SYSTEMS _0248322 FRONT SEAT SIDE AIRBAG ASSEMBLY(for Driver Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY(for Driver Side)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).

·

If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one.

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



NOTICE:

Always use "TORX" socket wrench E10 when removing the front seat.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 73230 3.REMOVE FRONT SEAT INNER BELT ASSEMBLY

Hide 71910A 4.REMOVE FRONT SEAT HEADREST ASSEMBLY

HINT:

Use the same procedure as for the LHD (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Driver Side)>DISASSEMBLY).


Hide 72525A 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE

HINT:

Use the same procedure as for the LHD (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Driver Side)>DISASSEMBLY).


Hide 72494 6.REMOVE VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)

HINT:

Use the same procedure as for the LHD (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Driver Side)>DISASSEMBLY).


Hide 71811D 7.REMOVE FRONT SEAT CUSHION SHIELD

HINT:

Use the same procedure as for the LHD (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Driver Side)>DISASSEMBLY).


Hide 71861 8.REMOVE FRONT SEAT CUSHION INNER SHIELD

HINT:

Use the same procedure as for the LHD (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Driver Side)>DISASSEMBLY).


Hide 9.REMOVE FRONT SEATBACK COVER WITH PAD

a.
B287791

Disconnect the seatback cover band.


b.
B287792

Unfasten the hook and loop fastener.


c.
B289893

Remove the 3 hog rings.


d.
B289894

Remove the 3 hog rings.


e.
B272974

Unfasten the 2 zippers. (for Sport Package)


f.
B272764

Disengage the 4 claws to remove the 2 front seat headrest supports.


g.
B289856

Remove the 2 nuts and the seatback bracket.


h.

Remove the front seatback cover with pad.


Hide 10.REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY

a.
B288456

Disengage the 7 clamps.


b.
B272934

Disengage the 2 clamps to separate the front seat side airbag wire harness.


c.
B287807

Remove the 2 nuts and the front seat side airbag assembly.

CAUTION:
·

The nuts must not be reused.

·

Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.