Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67913
3.REMOVE FRONT DOOR SCUFF PLATE RH
67917A
4.REMOVE REAR DOOR SCUFF PLATE RH
62311B
5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62331A
6.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
62413A
7.REMOVE CENTER PILLAR LOWER GARNISH RH
89860
8.REMOVE SIDE AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Disconnect the connector from the side airbag sensor assembly.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Push and hold the white housing lock, and slide the yellow outer connector locking sleeve.
| *1 | Housing Lock | *2 | Outer Connector Locking Sleeve |
| *a | Slide | - | - |
Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.
Remove the bolt and side airbag sensor assembly.
Loosen the bolt while holding the side airbag sensor assembly because the side airbag sensor assembly pin (stopper) is easily damaged.