Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › MASS AIR FLOW METER › from 2016.09
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248060 MASS AIR FLOW METER A

2NZ-FE ENGINE CONTROL  MASS AIR FLOW METER  INSTALLATION  


PROCEDURE

Hide 22204 1.INSTALL MASS AIR FLOW METER

a.

Install a new O-ring to the mass air flow meter.

NOTICE:

Do not twist the O-ring.



b.

Install the mass air flow meter with the 2 screws.

Torque:
1.0 N*m (10 kgf*cm, 9 in.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.



HINT:

Perform "Inspection After Repairs" after replacing the mass air flow meter.

Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



c.

Connect the connector mass air flow meter.


d.

Engage the wire harness clamp.


Hide 2.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the mass air flow meter.

Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION