77174
1.INSTALL NO. 1 FUEL SUCTION SUPPORT
Perform "Inspection After Repair" after replacing the fuel pump.
Click hereEngine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>INITIALIZATION
Install a new O-ring to the No. 1 fuel suction support.
Engage the 2 claws of the No. 1 fuel suction support guide and the 3 claws of the No. 1 fuel suction support, and install the No. 1 fuel suction support.
23280J
2.INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
Coat a new O-ring with gasoline and install it to the fuel pressure regulator assembly.
Install the fuel pressure regulator assembly to the No. 1 fuel suction support.
77175
3.INSTALL NO. 2 FUEL SUCTION SUPPORT
Align the 3 claws and the clamp, and install the No. 2 fuel suction support.
23221
4.INSTALL FUEL PUMP
Holding the fuel pump filter by the plastic resin part, install the fuel pump.
Be careful not to let foreign matter enter the fuel pump or the fuel pump filter.
Apply gasoline to a new O-ring, and then install the fuel pump spacer and new O-ring onto the fuel pump.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
Make sure the O-ring is not damaged and has no foreign matter stuck to it.
Align the three claws and install the fuel pump filter to the No. 1 fuel suction support.
Do not push the filter part of the fuel filter.
77785
5.INSTALL FUEL PUMP HARNESS
Connect the 2 connectors and install the fuel pump harness.
83320
6.INSTALL FUEL SENDER GAUGE ASSEMBLY