Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › SFI SYSTEM › from 2016.09
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248054 SFI SYSTEM L

2NZ-FE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


INITIALIZATION


NOTICE:
·

If the ECM is replaced, register the ECU communication ID for Immobiliser System (refer to the registration procedures for Service Bulletin).


·

Perform Registration (VIN registration) when replacing the ECM (See page Engine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>REGISTRATION).

·

Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (See page Drivetrain>U441E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION).

·

Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM (See page Engine / Hybrid System>2NZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION).



HINT:
·

The engine learned value cannot be reset by disconnecting the battery negative (-) terminal or removing the EFI MAIN and ETCS fuses.

·

Refer to Initialization to perform Learning Value Reset and idle learning (See pageEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).




WHEN USING GTS


CAUTION:
Observe the following items for safety reasons:
·

Before using the GTS read the instruction manual.

·

Make sure that the GTS cable is not caught on the pedals, shift lever and steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes while using the GTS, 2 persons are required. One person drives the vehicle, the other operates the GTS.