All bolts, screws and relevant to installing and removing the instrument panel are shown, along with their alphabetic codes, in the table below.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
62311B
3.SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Separate the front door opening trim weatherstrip RH.
62312B
4.SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Separate the front door opening trim weatherstrip LH.
62211
5.REMOVE FRONT PILLAR GARNISH RH
62212
6.REMOVE FRONT PILLAR GARNISH LH
Use the same procedure as for the RH side.
55411G
7.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL
Apply protective tape, as shown in the illustration.
| *a | Protective Tape |
Disengage the 6 clips to remove the No. 1 instrument cluster finish panel.
55475B
8.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH
Open the No. 1 instrument panel box door sub-assembly.
Disengage the 9 clips to remove the center instrument cluster finish panel garnish.
55405B
9.REMOVE INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY (w/o Audio)
Disengage the 6 clips in the order shown in the illustration, and separate the instrument cluster finish center panel sub-assembly.
To avoid damaging the hazard warning signal switch assembly connector or wire harness, do not pull too forcefully.
Disconnect the connector to remove the instrument cluster finish center panel sub-assembly.
55445C
10.REMOVE INSTRUMENT PANEL BOX PLATE
Remove the instrument panel box plate.
55041B
11.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY
Disengage the 9 clips and 2 claws to remove the No. 1 instrument panel box door sub-assembly.
55660
12.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
Disengage the 4 claws and 4 guides to remove the No. 4 instrument panel register assembly.
83100
13.REMOVE COMBINATION METER ASSEMBLY
55302A
14.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
Slide the slider and disconnect the front passenger airbag connector.
| *1 | Slider |
Remove the <B> bolt.
Disengage the clamps.
Disconnect the connectors.
Remove the 2 clips.
Remove the <C> screw.
Disengage the 6 clips while lifting the rear side of the upper instrument panel sub-assembly.
While lifting the instrument panel, slide it toward the rear of the vehicle. Disengage the 5 guides of the front side of the upper instrument panel sub-assembly to remove the upper instrument panel sub-assembly.
Be careful not to damage the upper instrument panel sub-assembly and steering wheel when removing it.