Perform "Inspection After Repairs" after replacing the cylinder head sub-assembly.
Click hereEngine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>INITIALIZATION
11151A
1.INSTALL CAMSHAFT BEARING CAP SETTING RING PIN
Using a plastic-faced hammer, tap a new ring pin in to the specified protrusion height.
4.5 to 5.5 mm (0.177 to 0.217 in.)
17111Z
2.INSTALL STUD BOLT
Using "TORX" socket wrenches E5 and E7, install the 11 stud bolts.
13711E
3.INSTALL VALVE STEM OIL SEAL
Apply a light coat of engine oil to the valve stem oil seal.
| *a | Intake |
| *b | Exhaust |
| *c | Gray |
| *d | Black |
Installing the oil seal for intake and exhaust onto the opposite valve guide bush may cause failures.
The intake valve oil seal is gray and the exhaust valve oil seal is black.
Using SST, push in a new oil seal.
13711
4.INSTALL INTAKE VALVE
Install the valve, spring seat, valve spring, and spring retainer.
Install the parts into their original locations in the original order.
Using SST, compress the spring and install the 2 retainer locks.
Using a pin-punch (5 mm) and the valve stem (not in use) with its tip wrapped in tape, gently tap the valve stem tip to ensure a proper fit.
Do not damage the valve stem tip.
13715
5.INSTALL EXHAUST VALVE
Install the valve, spring seat, valve spring, and spring retainer.
Using SST, compress the spring and install the 2 retainer locks.
Using a pin-punch (5 mm) and the valve stem (not in use) with the tip wrapped in tape, lightly tap the valve stem tip to ensure a proper fit.
Do not damage the valve stem tip.
15678A
6.INSTALL OIL CONTROL VALVE FILTER
Install the oil control valve filter.
| *1 | Oil Control Valve Filter |
11117B
7.INSTALL NO. 2 WITH HEAD TAPER SCREW PLUG
Using an 8 mm socket hexagon wrench, install the No. 2 with head taper screw plug and a new gasket.
11117A
8.INSTALL NO. 1 WITH HEAD TAPER SCREW PLUG
Using a 14 mm socket hexagon wrench, install the No. 1 with head taper screw plug and a new gasket.