Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense) › from 2017.01
RM19S0E _57 Power Source / Network _051489 NETWORKING _0307624 CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense) D

NETWORKING  CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense)  SYSTEM DESCRIPTION  


BRIEF DESCRIPTION


a.

The CAN (Controller Area Network) is a serial data communication system for real-time application. It is a vehicle multiplex communication system which has a high communication speed (500 kbps, 250 kbps) and the ability to detect malfunctions.


b.

By pairing the CANH and CANL bus lines, the CAN performs communication based on differential voltages.


c.

Many ECUs (sensors) installed on the vehicle operate by sharing information and communicating with each other.


d.

The CAN has 2 resistors of 120 Ω which are necessary to communicate using the main wire.



DEFINITION OF TERMS


a.

Main wire

i.

The main wire is a wire harness between the 2 termination circuits on the bus (communication line). This is the main bus in the CAN communication system.



b.

Branch wire

i.

The branch wire is a wire harness which diverges from the main wire to an ECU or sensor.



c.

Termination circuits

i.

The termination circuit is a circuit which converts the communication current of the CAN communication into the bus voltage. It consists of a resistor and capacitor. 2 termination circuits are necessary on a bus.



d.

CAN junction connector

i.

The CAN junction connector is designed so that it can be used with CAN communication which has a termination circuit and CAN communication which does not have a termination circuit.




CIRCUIT DESCRIPTION


a.

The V bus, power train bus and local bus each have termination circuits with a resistance of 120 Ω x 2. High speed communication at 500 kbps and 250 kbps is possible.



ECUS OR SENSORS WHICH COMMUNICATE VIA CAN COMMUNICATION SYSTEM


a.

CAN V Bus

i.

ECM


ii.

Airbag sensor assembly


iii.

Skid control ECU (brake actuator assembly)


iv.

Steering angle sensor (spiral cable sub-assembly)


v.

Air conditioning amplifier assembly


vi.

Main body ECU (multiplex network body ECU)


vii.

Power steering ECU assembly


viii.

Combination meter assembly


ix.

Radio and display receiver assembly*1


x.

Navigation receiver assembly*2


xi.

DLC3

*1: for Radio and Display Type

*2: for Navigation Receiver Type





DIAGNOSTIC CODES FOR CAN COMMUNICATION SYSTEM


HINT:

See Diagnosis System (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense)>DIAGNOSIS SYSTEM).



NOTES REGARDING TROUBLESHOOTING


a.

Trouble in the CAN bus (communication line) can be checked through the DLC3 (except when there is a wire break in the branch wire of the DLC3).


b.

DTCs regarding the CAN communication system can be checked using the intelligent tester.


c.

The CAN communication system cannot detect trouble in the branch line of the DLC3 even though the DLC3 is also connected to the CAN communication system.



HOW TO DISTINGUISH CAN JUNCTION CONNECTOR CONNECTORS


a.

In the CAN communication system, the shape of all connectors connected to the CAN junction connector is the same.

The connectors connected to the CAN junction connector can be distinguished by the colors of the bus line and the connecting side of the connector.

HINT:

Refer to "Terminals of ECU" (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense)>TERMINALS OF ECU) for bus line color or the connecting side of the connector.