CHECK PRE-CRASH SAFETY SYSTEM CANCEL SWITCH ASSEMBLY
Check pre-crash safety system cancel switch assembly (warning timing adjustment)
| *a | Far | *b | Middle |
| *c | Near | - | - |
Turn the ignition switch to ON.
Operate the pre-crash safety system switch to change the warning timing of the pre-crash safety system between 3 levels and check that the warning timing adjustment display on the LCD display changes between "Far", "Middle" and "Near".
Information about warning timing adjustment is displayed for 6 seconds on the LCD display.
"Middle" is the default setting.
Check pre-crash safety system cancel switch assembly (system on/off)
| *a | PCS Warning Light (PCS OFF Indicator) |
Turn the ignition switch to ON.
When the pre-crash safety system cancel switch assembly is pressed and held for 3 seconds or more, check that the PCS warning light (PCS OFF indicator) in the combination meter assembly illuminates "PCS OFF" is displayed in the LCD display of the combination meter assembly.
Even if the ignition switch is turned off with the pre-crash safety system off, the system will turn on when the ignition switch is turned to ON again.