Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › from 2017.01
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0307843 LANE DEPARTURE ALERT SYSTEM U

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  TERMINALS OF ECU  


CHECK PRE-CRASH SAFETY CITY SENSOR


E256359E80
2.01,0.75 2.417,1 0.406,0.25 2.094,0.781 2.552,0.979 0.458,0.198 10 false L11

a.

Disconnect the L11 pre-crash safety city sensor connector.

NOTICE:
·

DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.

·

If a load of more than 10 kg (22 lb) is placed on the connector, it may break. Do not place more load than is necessary on the connector.




b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
L11-3 (LDSW) - Body ground BE - Body ground Resistance Lane departure switch being pressed Below 1 Ω
L11-3 (LDSW) - Body ground BE - Body ground Resistance Lane departure switch not being pressed 100 kΩ or higher
L11-7 (IG1) - Body ground G - Body ground Power source Ignition switch ON 11 to 14 V
L11-7 (IG1) - Body ground G - Body ground Power source Ignition switch off Below 1 V
L11-10 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω


c.

Reconnect the L11 pre-crash safety city sensor connector.


d.

Check for pulses according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
L11-5 (CA1P) - Body ground LG - Body ground CAN communication signal Ignition switch ON Pulse generation (Refer to waveform 1)
L11-11 (CA1N) - Body ground W - Body ground CAN communication signal Ignition switch ON Pulse generation (Refer to waveform 1)

HINT:

If the result is not as specified, there is a CAN bus line, terminating resistor circuit (or product with this circuit) or pre-crash safety city sensor malfunction.



e.
A382368E01
0.083,0.073 0.396,0.271 0.313,0.198 10 false *a 0.302,0.667 0.615,0.865 0.313,0.198 10 false CH1 0.333,1.333 0.646,1.531 0.313,0.198 10 false CH2 2.99,1.198 3.302,1.396 0.313,0.198 10 false GND 3,1.583 3.313,1.781 0.313,0.198 10 false GND

Reference (Oscilloscope waveform)

Text in Illustration
*a Waveform 1

Measurement Condition
Item Content
Measurement Terminal
·

CH1: L11-5 (CA1P) - Body ground

·

CH2: L11-11 (CA1N) - Body ground


Measurement Setting 1 V/DIV., 50 μsec./DIV.
Condition Ignition switch ON