Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › from 2017.01
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0307843 LANE DEPARTURE ALERT SYSTEM D

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  SYSTEM DESCRIPTION  


LANE DEPARTURE ALERT SYSTEM DESCRIPTION


a.

When driving on roads with white (or yellow) lines, when the system determines that the vehicle may deviate from the current driving lane, it informs the driver of the potential deviation with a buzzer and a display on the combination meter assembly.


b.

The system is equipped with a last memory function, which stores the switch condition when the engine stops and allows the system to begin in that condition when the engine is started again.



FUNCTION OF COMPONENTS


Component Function
Pre-crash Safety City Sensor
·

Acquires information about the road ahead from a monocular camera and controls the lane departure alert system.

·

Sends signals to illuminate the LDA indicator and sound the meter buzzer based on lane departure alert system control information.

·

Determines the condition of the lane departure alert switch.


Lane Departure Alert Switch Turn the lane departure alert system on/off.
Combination Meter Assembly
·

Displays the control condition (ON/OFF) and warning sensitivity of the lane departure alert system.

·

During a system malfunction, warns the driver by illuminating the LDA indicator and sounding the meter buzzer.

·

Sends the meter tolerance values and turn signal condition to the pre-crash safety city sensor.


Skid Control ECU (Brake Actuator Assembly) Sends the wheel speed signals to the pre-crash safety city sensor.
Spiral Cable with Sensor Sub-assembly (Steering Angle Sensor) Detects the steering angle and steering direction.
Airbag Sensor Assembly (Yaw Rate Sensor) Sends yaw rate sensor signals to the pre-crash safety city sensor.


LANE DEPARTURE ALERT SYSTEM CONTROL


a.

Lane departure alert system start-up conditions

i.

The lane departure alert system operates when the following conditions are met.

System Start-up Conditions
Lane departure alert switch ON
Vehicle speed within operating range for lane departure alert system
Lane recognized
Turn signals not being operated
No system malfunctions detected



b.

Lane departure alert system operation conditions

i.

The lane departure alert system operates while the vehicle is in the following conditions.

System Operation Conditions
Operating speed Between approximately 50 and 200 km/h (32 and 124 mph)
Operating lane width Approximately 3.0 m (9.84 ft.) or more
Operating radius On a straight road or slight curve (with a radius of approximately 150 m (492 ft.) or more)



c.

Temporary function cancellation during lane departure alert system operation

i.

The lane departure alert system is temporarily canceled when the following conditions (cancellation conditions) are detected.


ii.

The lane departure alert system restarts when the following conditions (recovery conditions) are met.

Cancellation Conditions Recovery Conditions
Vehicle speed outside operating range for lane departure alert system Vehicle speed within operating range for lane departure alert system
Turn signals being operated Turn signals not being operated
Lane not recognized Lane recognized
Immediately after lane departure alert sounds In-lane driving recognized several seconds after lane departure alert operates



d.

Lane departure alert system stop/restart

i.

The lane departure alert system stops when the following conditions (stop conditions) are detected.


ii.

The lane departure alert system restarts when the following conditions (restart conditions) are met.

Stop Conditions Restart Condition
Lane departure alert switch OFF Lane departure alert switch ON
Lane departure alert system temporarily canceled Normal condition confirmed
Lane departure alert system malfunction detected
·

Normal condition confirmed after engine start-up

·

Recovered from communication malfunction between pre-crash safety city sensor and connected ECU

·

Recovered from other malfunction between pre-crash safety city sensor and connected ECU



HINT:

For the fail-safe of the lane departure alert system (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>FAIL-SAFE CHART).