CHECK LANE DEPARTURE ALERT SWITCH (COMBINATION SWITCH ASSEMBLY)
Check lane departure alert switch (combination switch assembly).
Turn the ignition switch to ON.
Confirm that the LDA indicator (green) in the combination meter assembly illuminates or turns off when the lane departure alert switch (combination switch assembly) is pressed.
| *a | LDA Indicator |
The ON/OFF status of the lane departure alert system remains unchanged when the ignition switch is turned off and back to ON.
Check lane departure alert system (warning sensitivity customization)
Turn the ignition switch to ON.
While the odometer is being displayed, press and hold the ODO/TRIP DISP switch until the display changes, and change the drive monitor to customize mode.
Select lane departure alert sensitivity from the customization items, and check that the warning sensitivity of the lane departure alert system changes.