Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH › from 2017.01
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0308090 LANE DEPARTURE ALERT SWITCH G

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT LANE DEPARTURE ALERT SWITCH (COMBINATION SWITCH ASSEMBLY)

a.

Check the resistance.

i.
C335690C04
1.271,1.833 1.615,1.333 true 2.5,1.833 2.167,1.333 true 0.979,1.771 1.438,1.969 0.458,0.198 10 false ECU 2.552,1.76 3.01,1.958 0.458,0.198 10 false GND 0.083,0.083 0.375,0.281 0.292,0.198 10 false *a
*a Component without harness connected
(Lane Departure Alert Switch (Combination Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (ECU) - 2 (GND) Lane departure alert switch (combination switch assembly) ON Below 1 Ω
Lane departure alert switch (combination switch assembly) OFF 10 kΩ or higher


If the result is not as specified, replace the lane departure alert switch (combination switch assembly).



b.
C335690C05
2.635,1.917 2.302,1.333 true 1.135,1.917 1.469,1.333 true 0.083,0.083 0.396,0.281 0.313,0.198 10 false *a 0.792,1.854 1.188,2.021 0.396,0.167 10 false ILL+ 2.698,1.844 3.094,2.01 0.396,0.167 10 false ILL-
*a Component without harness connected
(Lane Departure Alert Switch (Combination Switch Assembly))


Check the illuminates.

i.

Apply battery voltage between the terminals of the lane departure alert switch (combination switch assembly) and check that the illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 6 (ILL+)
Battery negative (-) → Terminal 1 (ILL-)
Illuminates


If the result is not as specified, replace the lane departure alert switch (combination switch assembly).