87940
1.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH
| *a | Component without harness connected
(Outer Rear View Mirror Assembly LH) |
Check the outer rear view mirror operation.
Apply battery voltage and check the operation of the outer rear view mirror.
| Battery Connection | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 5 (MV)
Battery negative (-) → Terminal 4 (M+) |
Turns upward |
| Battery positive (+) → Terminal 4 (M+)
Battery negative (-) → Terminal 5 (MV) |
Turns downward |
| Battery positive (+) → Terminal 3 (MH)
Battery negative (-) → Terminal 4 (M+) |
Turns left |
| Battery positive (+) → Terminal 4 (M+)
Battery negative (-) → Terminal 3 (MH) |
Turns right |
If the result is not as specified, replace the outer rear view mirror assembly LH.
| *a | Component without harness connected
(Outer Rear View Mirror Assembly LH) |
Check the mirror heater. (w/ Mirror Heater)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (+) - 1 (-) | 25°C (75°F) | 8.6 to 12.9 Ω |
If the result is not as specified, replace the outer rear view mirror assembly LH.
87910
2.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH
| *a | Component without harness connected
(Outer Rear View Mirror Assembly RH) |
Check the outer rear view mirror operation.
Apply battery voltage and check the operation of the outer rear view mirror.
| Battery Connection | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 5 (MV)
Battery negative (-) → Terminal 4 (M+) |
Turns upward |
| Battery positive (+) → Terminal 4 (M+)
Battery negative (-) → Terminal 5 (MV) |
Turns downward |
| Battery positive (+) → Terminal 3 (MH)
Battery negative (-) → Terminal 4 (M+) |
Turns left |
| Battery positive (+) → Terminal 4 (M+)
Battery negative (-) → Terminal 3 (MH) |
Turns right |
If the result is not as specified, replace the outer rear view mirror assembly RH.
| *a | Component without harness connected
(Outer Rear View Mirror Assembly RH) |
Check the mirror heater. (w/ Mirror Heater)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (+) - 1 (-) | 25°C (75°F) | 8.6 to 12.9 Ω |
If the result is not as specified, replace the outer rear view mirror assembly RH.