CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (w/ Mirror Heater)
Disconnect the F42 air conditioning amplifier assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F42-1 (IG+) - F42-14 (GND) | V - W-B | Power source (IG) | Ignition switch ON | 11 to 14 V |
| F42-1 (IG+) - F42-14 (GND) | V - W-B | Power source (IG) | Ignition switch off | Below 1 V |
| F42-21 (B) - F42-14 (GND) | BE - W-B | Battery power supply | Always | 11 to 14 V |
| F42-14 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
If the result is not as specified, there may be a malfunction in the wire harness.
Reconnect the F42 air conditioning amplifier assembly connector.
Measure the voltage and check for pulses according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F42-38 (RDFG) - F42-14 (GND) | B - W-B | Mirror heater switch signal | Ignition switch ON, rear window defogger switch off | 11 to 14 V |
| F42-38 (RDFG) - F42-14 (GND) | B - W-B | Mirror heater switch signal | Ignition switch ON, rear window defogger switch on | Below 1 V |
| F42-37 (LIN1) - F42-14 (GND) | LG - W-B | LIN communication line | Ignition switch ON | Pulse generation |
If the result is not as specified, the air conditioning amplifier assembly may be malfunctioning.
CHECK AIR CONDITIONING CONTROL ASSEMBLY (w/ Mirror Heater )
Check for pulses according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F40-3 (LIN1) - F40-8 (GND) | LG - BR | LIN communication line | Ignition switch ON | Pulse generation |
If the result is not as specified, the air conditioning control assembly may be malfunctioning.