Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH BRAKE CANCEL SWITCH › from 2017.01
RM19S0E _58 Vehicle Interior _063185 PRE-CRASH SAFETY _0309287 PRE-CRASH BRAKE CANCEL SWITCH G

PRE-CRASH SAFETY  PRE-CRASH BRAKE CANCEL SWITCH  INSPECTION  


PROCEDURE

Hide 84770A 1.INSPECT PRE-CRASH SAFETY SYSTEM CANCEL SWITCH ASSEMBLY

a.
E315631C03
0.958,0.781 1.448,1.083 true 1.844,1.24 2.333,1.542 true 2.01,1.083 2.365,0.667 true 1.104,1.615 1.604,1.229 true 0.094,0.083 0.479,0.365 0.385,0.281 10 false *a 0.667,0.708 1.052,0.99 0.385,0.281 10 false ECU 2.438,0.594 2.823,0.875 0.385,0.281 10 false GND 0.802,1.552 1.188,1.833 0.385,0.281 10 false ILL+ 2.406,1.5 2.792,1.781 0.385,0.281 10 false ILL-
*a Component without harness connected
(Pre-crash Safety System Cancel Switch Assembly)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (ECU) - 1 (GND) Pre-crash safety system cancel switch assembly on Below 1 Ω
Pre-crash safety system cancel switch assembly off 10 kΩ or higher


If the result is not as specified, replace the pre-crash safety system cancel switch assembly.



b.

Check that the illuminates.

i.

Apply battery voltage to the pre-crash safety system cancel switch assembly and check that it illuminates.

OK:
Tester Connection Switch Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 2 (ILL-)
Illuminates


If the result is not as specified, replace the pre-crash safety system cancel switch assembly.