Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM WARNING BUZZER › 2017.01–2018.06
RM19S0E _58 Vehicle Interior _063185 PRE-CRASH SAFETY _0309288 PRE-CRASH SAFETY SYSTEM WARNING BUZZER G

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM WARNING BUZZER  INSPECTION  


PROCEDURE

Hide 86652E 1.INSPECT PRE-CRASH SAFETY CITY BUZZER

a.

Make sure that there is no looseness at the locking part and the connecting part of the connector.


b.

Disconnect the pre-crash safety city buzzer connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



d.
A303614

Connect a negative (-) lead from the battery to terminal 2, and a positive (+) lead to terminal 1 of the pre-crash safety city buzzer, and then check that the buzzer sounds.

OK:

The pre-crash safety city buzzer sounds.


If the result is not as specified, replace the pre-crash safety city buzzer.