Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
52159
1.REMOVE REAR BUMPER COVER
64746
2.REMOVE REAR COMBINATION LIGHT SERVICE COVER
Using a moulding remover A, disengage the 4 claws.
Disengage the 2 guides to remove the rear combination light service cover.
81560
3.REMOVE REAR COMBINATION LIGHT ASSEMBLY
Disconnect the connector.
Remove the 2 nuts.
Remove the screw.
Disengage the 3 clips and 2 pins to remove the rear combination light assembly with the rear bumper side support.
Remove the 2 screw and rear bumper side support.
81496C
4.REMOVE NO. 2 REAR COMBINATION LIGHT GUIDE
Remove the 2 No. 2 rear combination light guides from the body.