81590A
1.INSPECT REAR LIGHT ASSEMBLY LH (for LED Type Stop Light)
| *a | Component without harness connected
(Rear Light Assembly LH) |
Apply battery voltage to the rear light assembly LH and check that the light comes on.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 2 (B)
Battery negative (-) → Terminal 1 (E) |
Back up light comes on |
If the result is not as specified, replace the rear combination light assembly LH.
81580D
2.INSPECT REAR LIGHT ASSEMBLY RH (for LED Type Stop Light)
| *a | Component without harness connected
(Rear Light Assembly RH) |
Apply battery voltage to the rear light assembly RH and check that the light comes on.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 2 (B)
Battery negative (-) → Terminal 1 (E) |
Back up light comes on |
If the result is not as specified, replace the rear combination light assembly RH.
81590A
3.INSPECT REAR LIGHT ASSEMBLY LH (for Bulb Type Stop Light)
| *a | Component without harness connected
(Rear Light Assembly LH) |
Apply battery voltage to the rear light assembly LH and check that the light comes on.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 3 (B)
Battery negative (-) → Terminal 1 (E) |
Back up light comes on |
| Battery positive (+) → Terminal 2 (TL)
Battery negative (-) → Terminal 1 (E) |
Taillight comes on |
If the result is not as specified, replace the rear combination light assembly LH.
81580D
4.INSPECT REAR LIGHT ASSEMBLY RH (for Bulb Type Stop Light)
| *a | Component without harness connected
(Rear Light Assembly RH) |
Apply battery voltage to the rear light assembly RH and check that the light comes on.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 3 (B)
Battery negative (-) → Terminal 1 (E) |
Back up light comes on |
| Battery positive (+) → Terminal 2 (TL)
Battery negative (-) → Terminal 1 (E) |
Taillight comes on |
If the result is not as specified, replace the rear combination light assembly RH.