Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR › from 2017.01
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248230 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 53876A 2.REMOVE FRONT FENDER LINER

a.

Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.

C370508C01
3.063,2.292 3.74,1.865 true 0.448,3.333 0.802,3.333 false 2.271,3.344 2.625,3.344 false 4.396,1.438 4.698,1.542 false 4.646,1.854 4.604,2.271 4.604,2.271 4.76,2.125 false 5.229,2.552 5.521,2.927 5.521,2.927 5.479,2.677 false 3.781,1.771 4.073,1.969 0.292,0.198 10 true *1 3.688,2.875 4,3.073 0.313,0.198 10 false *a 0.271,3.281 0.563,3.479 0.292,0.198 10 false *2 2.667,3.271 2.958,3.469 0.292,0.198 10 false *2 4.198,1.344 4.49,1.542 0.292,0.198 10 false *3 4.49,2.333 4.781,2.531 0.292,0.198 10 false *3 5.49,2.979 5.781,3.177 0.292,0.198 10 false *3
*1 Pin Hold Clip *2 Grommet (A)
*3 Grommet (B) - -
*a 90° - -



b.

Remove the 7 clips, 3 screws, 2 grommets (A) and 5 grommets (B) and remove the front fender liner.

HINT:

The grommet (B) needs to be replaced with a new one because it will break when it is removed.



Hide 89543 3.REMOVE FRONT SPEED SENSOR

a.

Disengage the front speed sensor connector clamp from the body.

C259620C02
4.969,0.625 5.198,0.469 false 1.885,2.281 2.146,2.333 false 5.646,1.74 5.74,1.479 false 2.177,2.281 2.49,2.438 0.313,0.156 10 *1 5.781,1.385 6.094,1.542 0.313,0.156 10 *2 4.802,0.573 5.115,0.729 0.313,0.156 10 *3
*1 No. 1 Clamp *2 No. 2 Clamp
*3 No. 3 Clamp - -



b.

Disconnect the front speed sensor connector.


c.

Remove the No. 3 clamp from the body.


d.

Disengage the 2 clamps to separate the wire harness from the body.


e.

Remove the bolt and separate the No. 2 clamp from the body.


f.

Remove the bolt and separate the No. 1 clamp from the shock absorber.


g.

Remove the bolt and front speed sensor from the steering knuckle.

NOTICE:
·

Keep the front speed sensor tip and installation portion free of foreign matter.

·

Remove the front speed sensor without turning it from its original installation angle.