Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR › from 2017.01
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248230 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  INSTALLATION  


PROCEDURE

Hide 89543 1.INSTALL FRONT SPEED SENSOR

a.

Install the front speed sensor to the steering knuckle with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Check that the front speed sensor tip and installation portion are free of foreign matter.

·

Install the front speed sensor without turning it from its original installation angle.




b.

Install the No. 1 clamp to the shock absorber with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)

NOTICE:

Do not twist the front speed sensor wire harness when installing it.



c.

Install the No. 2 clamp to the body with the bolt.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)

NOTICE:

Do not twist the front speed sensor wire harness when installing it.



d.

Engage the 2 clamps to the body.


e.

Install the No. 3 clamp to the body.


f.

Connect the front speed sensor connector.


g.

Engage the clamp to the body.


Hide 53876A 2.INSTALL FRONT FENDER LINER

a.

Install the front fender liner with the 7 clips, 2 grommets (A) and 5 new grommets (B).

C372991C03
3.063,2.292 3.844,1.823 true 4.375,1.448 4.708,1.552 false 4.604,1.865 4.646,2.354 4.646,2.354 4.75,2.115 false 5.219,2.563 5.51,2.979 5.51,2.979 5.479,2.677 false 2.271,3.333 2.604,3.333 false 0.438,3.333 0.802,3.333 false 3.896,1.729 4.156,1.927 0.26,0.198 10 true *1 3.365,2.75 3.625,2.948 0.26,0.198 10 false *a 4.031,2.75 4.292,2.948 0.26,0.198 10 false *b 4.167,1.375 4.479,1.573 0.313,0.198 10 false *3 4.563,2.427 4.875,2.625 0.313,0.198 10 false *3 5.469,3.031 5.781,3.229 0.313,0.198 10 false *3 2.677,3.26 2.99,3.458 0.313,0.198 10 false *2 0.219,3.26 0.531,3.458 0.313,0.198 10 false *2
*1 Pin Hold Clip *2 Grommet (A)
*3 Grommet (B) - -
*a Correct *b Incorrect



b.

Install the 3 screws.


c.

Install the pin hold clip as shown in the illustration.

NOTICE:
·

Insert the pin hold clip with the slot aligned vertically.

·

Do not rotate the clip after inserting it.

·

After installation, confirm that the slot is aligned vertically.




Hide 3.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)