Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR › from 2017.01
RM19S0E _59 Vehicle Exterior _051504 WIPER / WASHER _0248406 REAR WIPER MOTOR G

WIPER / WASHER  REAR WIPER MOTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85110R 1.INSPECT REAR WIPER MOTOR ASSEMBLY

a.
E358656C03
1.177,2.479 1.427,2.698 false 0.521,2.219 0.677,2.417 0.156,0.198 10 false A 0.531,2.521 0.688,2.719 0.156,0.198 10 false A 1.5,2.615 1.833,2.854 0.333,0.24 10 false *a
*a Alignment Mark


Check the automatic stop (park) position.

i.

Operate the rear wiper motor assembly.


ii.

Stop the rear wiper motor assembly operation.


iii.

Check the automatic stop (park) position.

HINT:

After the rear wiper motor is stopped, check the automatic stop (park) position after lifting the wiper blade 2 times.


Standard Clearance:
Area Measurement
A 20.0 mm (0.787 in.)


OK:

The rear wiper stops at the position shown in the illustration.