1.REMOVE FRONT BUMPER ASSEMBLY
|
Protective Tape |
Apply protective tape as shown in the illustration.
Use the same procedure for both sides.
Remove the 4 clips.
Remove the clip.
Use the same procedure for both sides.
| *1 | Pin Hold Clip |
| *a | 90 deg |
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clips.
Use the same procedure for both sides.
Remove the 5 screws and 3 bolts.
Disengage the 6 claws.
Use the same procedure for both sides.
w/ Fog Light:
Disconnect the 2 connectors.
Remove the front bumper assembly.
Remove the 5 grommets.
Remove the 2 nuts.