Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2017.01
RM19S0E _59 Vehicle Exterior _051507 EXTERIOR PANELS / TRIM _0248454 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

Install the 2 nuts.


b.

Install the 5 grommets.


c.

w/ Fog Light:

i.

Connect the 2 connectors.



d.

Engage the 6 claws to install the front bumper assembly.

HINT:

Use the same procedure for both sides.



e.

Install the 5 screws and 3 bolts.


f.
B465503

Install the pin hold clip.

NOTICE:

Insert the pin hold clip with the slot aligned vertically.

Do not rotate the clip after inserting it.

After installation, confirm that the slot is aligned vertically.


HINT:

Use the same procedure for both sides.



g.

Install the clip.

HINT:

Use the same procedure for both sides.



h.

Install the 4 clips.


i.

Remove the protective tape.


Hide 2.ADJUST FOG LIGHT AIMING (w/ Fog Light)