75741E
1.INSTALL SYMBOL EMBLEM
Clean the attachment surface.
Using a piece of cloth, rub the double-sided tape off the back door outside garnish sub-assembly.
Using a non-residue solvent, clean the attachment surface.
Using an infrared light, heat the back door outside garnish sub-assembly and a new symbol emblem.
| Item | Temperature |
|---|---|
| Back Door Outside Garnish Sub-assembly | 40 to 60°C (104 to 140°F)
3 to 5 minutes |
| Symbol Emblem | 20 to 30°C (68 to 86°F)
1 to 2 minutes |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Remove the peeling paper on the symbol emblem.
| *a | Location Pin |
Engage the 2 location pins to install the symbol emblem.
Apply sufficient pressure when attaching the symbol emblem to ensure proper adhesion.
75442
2.INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
Clean the attachment surface.
Using a piece of cloth, rub the double-sided tape off the back door outside garnish.
Using a non-residue solvent, clean the attachment surface.
Using an infrared light, heat the back door panel and a new No. 2 luggage compartment door name plate.
| Item | Temperature |
|---|---|
| Back Door Panel | 40 to 60°C (104 to 140°F)
3 to 5 minutes |
| No. 2 Luggage Compartment Door Name Plate | 20 to 30°C (68 to 86°F)
1 to 2 minutes |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Remove the peeling paper on the No. 2 luggage compartment door name plate.
Install the No. 2 luggage compartment door name plate as shown in the illustration.
| *a | Reference Values | *b | Edge of Back Door Panel |
| *c | 178.4 mm (7.024 in.) | *d | 95 mm (3.740 in.) |
| *e | 33.3 mm (1.311 in.) | *f | 42.7 mm (1.681 in.) |
Apply sufficient pressure when attaching the No. 2 luggage compartment door name plate to ensure proper adhesion.