Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM MAIN SWITCH › from 2017.01
RM19S0E _59 Vehicle Exterior _051505 LIGHTING (EXT) _0312393 AUTOMATIC HIGH BEAM MAIN SWITCH G

LIGHTING (EXT)  AUTOMATIC HIGH BEAM MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT AUTOMATIC HIGH BEAM MAIN SWITCH (COMBINATION SWITCH ASSEMBLY)

a.

Check the resistance.

i.
C335690C06
1.469,1.844 1.813,1.344 true 2.5,1.833 2.167,1.333 true 1.177,1.802 1.635,2 0.458,0.198 10 false +B 2.552,1.76 3.01,1.958 0.458,0.198 10 false GND 0.083,0.083 0.375,0.281 0.292,0.198 10 false *a
*a Component without harness connected
(Automatic High Beam Main Switch (Combination Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (+B) - 2 (GND) Automatic high beam main switch on Below 1 Ω
4 (+B) - 2 (GND) Automatic high beam main switch off 10 kΩ or higher


If the result is not as specified, replace the automatic high beam main switch (combination switch assembly).



b.

Check the illumination.

i.
C335690C07
2.635,1.917 2.302,1.333 true 1.135,1.917 1.469,1.333 true 0.083,0.083 0.396,0.281 0.313,0.198 10 false *a 0.792,1.854 1.188,2.021 0.396,0.167 10 false ILL+ 2.698,1.844 3.094,2.01 0.396,0.167 10 false ILL-
*a Component without harness connected
(Automatic High Beam Main Switch (Combination Switch Assembly))


Apply battery voltage to the automatic high beam main switch (combination switch assembly) and check that it illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 6 (ILL+)
Battery negative (-) → Terminal 1 (ILL-)
Illuminates


If the result is not as specified, replace the automatic high beam main switch (combination switch assembly).