Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2017.01
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0248153 CRUISE CONTROL SYSTEM U

CRUISE CONTROL  CRUISE CONTROL SYSTEM  FAIL-SAFE CHART  


HINT:

If the following conditions are detected while cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels cruise control.


Vehicle Condition Auto Cancel Condition Fail-safe Deactivation Condition
Cruise control indicator light blinks
·

There is an open or short in the stop light switch circuit

·

There is a problem with the vehicle speed signal


Turn the cruise control main switch on again
Cruise control indicator light goes off There is a problem with the throttle body with motor assembly
Cruise control indicator light blinks
·

There is a problem with the input circuit of the stop light switch circuit

·

There is a problem with the cancel circuit


·

Turn the cruise control main switch on again

·

Turn the ignition switch off and then to ON again


Cruise control indicator light remains on
(Cruise control is canceled)
Under either of the following conditions, cruise control operation is canceled but the stored vehicle speed is maintained:
·

The vehicle speed is less than the low speed limit (approximately 40 km/h (25 mph)) while driving with the cruise control system in operation

·

Vehicle stability control system operates while driving with cruise control system controlling vehicle speed

·

TRC system operates for a certain period of time while driving with cruise control system controlling vehicle speed

·

TRC is turned off

·

VSC is turned off


Push the cruise control main switch to +RES
Under the following condition, cruise control operation is canceled but the stored vehicle speed is maintained:
·

The vehicle speed is less than the stored speed by approximately 16 km/h (10 mph) or more


Push the cruise control main switch to -SET